Need metal roof installation in Bainbridge? We come look first, tell you plainly what it needs, and put the price in writing before anything starts.
We have been setting metal panels on houses, churches, barns and additions for over twenty years, and the crews serving Bainbridge install them the same way we always have. Straight lines, correct fastener spacing, and closures at the ridge so wind driven rain has nowhere to go.
Our metal roof installation work in Bainbridge is handled by crews who do this every week, not by whoever happened to be free that morning. It shows up in the details — valleys, chimney flashing, eave and ridge closures — because that is where roofs actually leak.
We schedule your Bainbridge metal roof installation for a stretch of dry weather, keep the job site picked up as we go, and do not leave a roof open overnight. When it is done the tear off is hauled away and a magnet goes over the drive.
Four steps and no surprises. This is how we have done it since 2002.
Panel type comes first — standing seam or exposed fastener — then color, then trim. We walk you through the trade offs on each one.
If the shingles are coming off, they come off, and every board underneath gets checked before anything new goes down.
We keep panels straight to a line rather than to the eye, because a metal roof shows every bit of drift the moment the sun hits it.
Every penetration gets a proper boot or flashing instead of a bead of sealant and a hope.
What comes up on just about every estimate for a job like this.
Around twenty standard colors. Green, burgundy, bronze, black, gray, tan and barn red are the ones most Bainbridge homeowners land on. We bring the chart with the estimate so you can hold it against your siding.
A straightforward Bainbridge house is usually three to five days. A cut up roof with dormers, valleys and multiple pitches takes longer, because every panel and trim piece gets measured and fit on site.
Most Bainbridge metal roof jobs land between about $12,000 and $30,000 in 2026, depending on square footage, pitch, panel type and how much tear off is involved. Standing seam runs higher than exposed fastener panels. We measure before we quote and the estimate is free.
Much less than people expect. Over solid decking with underlayment, a Bainbridge metal roof sounds about like a shingle roof from inside. The loud tin roof people remember was screwed to open purlins on a barn.
Real feedback from homeowners we have worked for.
"New gutters and guards after they did our roof. No more climbing up there every October to dig out pine needles by hand."
"Green metal over the whole house and the carport. Looks sharp, and it is quiet inside when it rains, which honestly surprised me."
"Straightforward from the first phone call. Free estimate, a clear price, no upselling, and the roof was finished in three days."